D-Link DES-3326S Command Line Interface Reference Manual page 82

show packet ports
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To display the packets analysis for port 14:
DES-3326S:4#show packet port 14
Command: show packet ports 14
Port number : 14
Frame Size Frame Counts Frames/sec
------------ ------------
64 254290
65-127 38129
128-255 51878
256-511 8058
512-1023 2046
1024-1518 5441
Unicast RX 2245
Multicast RX 57480
Broadcast RX 299782
D-Link DES-3326S Layer 3 Switch CLI Reference
Used to display statistics about the packets sent
and received by the Switch.
show packet ports <portlist>
This command is used to display statistics about
packets sent and received by ports specified in
the port list.
<portlist> − specifies a range of ports to be
configured. The port list is specified by listing
the lowest Switch number and the beginning
port number on that Switch, separated by a
colon. Then highest Switch number, and the
highest port number of the range (also
separeted by a colon) are specified. The
beginning and end of the port list range are
seperated by a dash. For example, 1:3 would
specify Switch number 1, port 3. 2:4 specifies
Switch number 2, port 4. 1:3-2:4 specifies all of
the ports between Switch 1, port 3 and Switch 2,
port 4 − in numerical order.
None.
Frame Type Total
---------- ----------
52 RX Bytes
12 RX Frames
13
3 TX Bytes
0 TX Frames
6
0
20
66
Total/sec
--------- ---------
41286744 17290
359507 86
72755 0
335 0
76