D-Link DES-3326S Command Line Interface Reference Manual page 232

create route redistribute dst rip
Purpose
Syntax
Description
Parameters
Restrictions
There are two routing information sources: OSPF and the Static Route table. Routing information will be
redistributed to RIP. The following table lists the allowed values for the routing metrics and the types (or forms)
of the routing information that will be redistributed.
Route Source
OSPF
Static
Entering the Type combination − internal type_1 type_2 is functionally equivalent to all. Entering the
combination type_1 type_2 is functionally equivalent to external. Entering the combination internal external
is functionally equivalent to all.
Entering the metric 0 specifies transparency.
Example Usage:
To add route redistribution settings:
DES-3326S:4#create route redistribute dst rip src ospf all metric 2
Command: create route redistribute dst rip src ospf all metric 2
Success.
DES-3326S:4#
D-Link DES-3326S Layer 3 Switch CLI Reference
Used to add route redistribution settings for the exchange of OSPF routes to
RIP routes on the Switch.
create route redistribute dst rip src [static|ospf
{all|internal|external|type_1|type_2}] {metric <value>}
This command will redistribute routing information between the OSPF and Rip
routing protocols to all routers on the network that are running OSPF or RIP.
Routing information entered into the Static Routing Table on the local DES-
3326S Switch is also redistributed
src [static|ospf {all|internal|external|type_1|type_2}] − Allows the selection of
the protocol of the source device.
metric <value> − Allows the entry of an OSPF interface cost. this is analogous
to a HOP Count in the RIP routing protocol.
Only administrator-level users can issue this command.
Metric
0 to 16
0 to 16
Type
all
type_1
type_2
internal type_1
internal type_2
external
internal
not applicable
226