D-Link DES-3326S Command Line Interface Reference Manual page 238

config igmp
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To configure the IGMP for the IP interface System.
DES-3326S:4#config igmp all version 1 state enable
Command: config igmp all version 1 state enable
Success.
DES-3326S:4#
D-Link DES-3326S Layer 3 Switch CLI Reference
Used to configure IGMP on the Switch.
config igmp [<ipif_name 12>|all] {version <value
1-2>|query_interval <sec
1 - 65535>|max_response_time < sec 1-25>|
robustness_variable <value 1-
255>|last_member_query_interval <value 1-
25>|state [enable|disable]}
This command is used to configure IGMP on the
Switch.
<ipif_name 12> − The name of the IP interface
for which you want to configure IGMP.
all − Specifies all the IP interfaces on the Switch.
version <value 1-2> − The IGMP version number.
query_interval <1-65535 sec> − The time in
seconds between general query transmissions,
in seconds.
max_response_time <1-25 sec> − the maximum
time in seconds that the Switch will wait for
reports from members.
robustness_variable <value1-255> − the
permitted packet loss that guarantees IGMP.
last_member_query_interval <value1-25> − the
Max Response Time inserted into Group-Specific
Queries sent in response to Leave Group
messages, and is also the amount of time
between Group-Specific Query messages. The
default is 1 second
state [enable|disable] − Enables or disables
IGMP for the specified IP interface.
Only administrator-level users can issue this
command.
232