D-Link DES-3326S Command Line Interface Reference Manual page 257

config rip rx_mode
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To change the RIP receive mode for the IP interface System.
DES-3326S:4#config rip ipif System rx_mode v1_only
Command: config rip ipif System rx_mode v1_only
Success.
DES-3326S:4#
D-Link DES-3326S Layer 3 Switch CLI Reference
Used to configure RIP on the Switch.
config rip [ipif <ipif_name 12>|all] rx_mode
[[disable|v1_only]|[v2_only|v1_or_v2]
authentication [enable|disable] <password>]
This command is used to configure RIP on the
Switch.
<ipif_name 12> − The name of the IP interface.
all – To configure all RIP receiving mode for all IP
interfaces.
rx_mode − Determines how received RIP
packets will be interpreted – as RIP version V1
only, V2 Only, or V1 Compatible (V1 or V2).
This entry specifies which version of the RIP
protocol will be used to receive RIP packets.
The Disabled entry prevents the reception of RIP
packets.
disable − Prevents the reception of RIP packets.
v1_only − Specifies that only RIP v1 packets will
be accepted.
v2_only − Specifies that only RIP v2 packets will
be accepted.
v1_or_v2 − Specifies that both RIP v1 and v2
packets will be accepted.
authentication [enable|disable] − Enables or
disables authentication for RIP on the Switch.
<password> − Allows the specification of a case-
sensitive password.
state [enable|disable] − Allows RIP to be enabled
and disabled on the Switch.
Only administrator-level users can issue this
command.
251