D-Link DES-3326S Command Line Interface Reference Manual page 40

show ports
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To display ports status:
DES-3326S:4#show ports
Command: show ports
Port Port Settings
State Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
------ -------- --------------------- --------------------- --------
1 Enabled Auto/Disabled
2 Enabled Auto/Disabled
3 Enabled Auto/Disabled
4 Enabled Auto/Disabled
5 Enabled Auto/Disabled
6 Enabled Auto/Disabled
7 Enabled Auto/Disabled
8 Enabled Auto/Disabled
9 Enabled Auto/Disabled
10 Enabled Auto/Disabled
11 Enabled Auto/Disabled
12 Enabled Auto/Disabled
13 Enabled Auto/Disabled
14 Enabled Auto/Disabled
15 Enabled Auto/Disabled
16 Enabled Auto/Disabled
17 Enabled Auto/Disabled
18 Enabled Auto/Disabled
19 Enabled Auto/Disabled
20 Enabled Auto/Disabled
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
D-Link DES-3326S Layer 3 Switch CLI Reference
Used to display the current configuration of a
range of ports.
show ports {<portlist>}
This command is used to display the current
configuration of a range of ports.
<portlist> − Specifies a range of ports to be
configured. The port list is specified by listing
the beginning port number and the highest port
number of the range. The beginning and end of
the port list range are separated by a dash. For
example, 3 would specify port 3. 4 specifies port
4. 3-4 specifies all of the ports between port 3
and port 4 − in numerical order.
none.
Connection
Link Down
Link Down
Link Down
Link Down
Link Down
Link Down
Link Down
Link Down
Link Down
100M/Full/None
Link Down
Link Down
Link Down
Link Down
Link Down
Link Down
100M/Full/None
Link Down
Link Down
Link Down
Address
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
34