D-Link DES-3326S Command Line Interface Reference Manual page 195

create cpu access_profile
Parameters ip − Specifies that the Switch will examine the IP address in each frame's header.
vlan − Specifies a VLAN mask.
source_ip_mask <netmask> − Specifies an IP address mask for the source IP
address.
destination_ip_mask <netmask> − Specifies an IP address mask for the destination
IP address. |
dscp − Specifies that the Switch will examine the DiffServ Code Point (DSCP) field in
each frame's header.
icmp − Specifies that the Switch will examine the Internet Control Message Protocol
(ICMP) field in each frame's header.
type − Specifies that the Switch will examine each frame's ICMP Type field.
code − Specifies that the Switch will examine each frame's ICMP Code field.
igmp − Specifies that the Switch will examine each frame's Internet Group
Management Protocol (IGMP) field.
type − Specifies that the Switch will examine each frame's IGMP Type field.
tcp − Specifies that the Switch will examine each frames Transport Control Protocol
(TCP) field.
src_port_mask <hex 0x0-0xffff> − Specifies a TCP port mask for the source port.
dst_port_mask <hex 0x0-0xffff> − Specifies a TCP port mask for the destination port.
flag_mask – Enter the appropriate flag_mask parameter. All incoming packets have
TCP port numbers contained in them as the forwarding criterion. These numbers
have flag bits asscociated with them which are parts of a packet that determine what
to do with the packet. The user may deny packets by denying certain flag bits within
the packets. The user may choose between all, urg (urgent), ack (acknowledgement),
psh (push), rst (reset), syn (synchronize) and fin (finish).
udp − Specifies that the Switch will examine each frame's Universal Datagram
Protocol (UDP) field.
src_port_mask <hex 0x0-0xffff> − Specifies a UDP port mask for the source port.
dst_port_mask <hex 0x0-0xffff> − Specifies a UDP port mask for the destination port.
protocol_id <value 0-255> − Specifies that the Switch will examine the protocol field
in each packet and if this field contains the value entered here, apply the following
rules
user_define_mask <hex 0x0-0xffffffff> − Specifies that the rule applies to the IP
protocol ID and the mask options behind the IP header.
profile_id <value 1-255> − Sets the relative priority for the profile. Priority is set
relative to other profiles where the lowest profile ID has the highest priority.
Restrictions Only administrator-level users can issue this command.
D-Link DES-3326S Layer 3 Switch CLI Reference
189