Configuring Static Ports - HP MSR2003 Configuration Manual

Setting the aging timers for dynamic ports globally
Step
1. Enter system view.
2. Enter IGMP-snooping view.
3. Set the aging timer for dynamic
router ports globally.
4. Set the global aging timer for
dynamic member ports globally.
Setting the aging timers for the dynamic ports in a VLAN
Step
1. Enter system view.
2. Enter VLAN view.
3. Set the aging timer for the dynamic
router ports in the VLAN.
4. Set the aging timer for the dynamic
member ports in the VLAN.

Configuring static ports

You can configure a port as a static port for the following purposes:
• To make all the hosts attached to the port receive multicast data addressed to a multicast group,
configure the port as a static member port for the multicast group.
To make the Layer 2 device attached to the port forward all received multicast traffic on the port,
•
configure the port as a static router port.
You can also configure a port as a static router port, through which the Layer 2 device can forward all
the multicast traffic it receives.
When you configure static ports, follow these guidelines:
• A static member port does not respond to queries from the IGMP querier. When you configure a
port as a static member port or cancel this configuration on the port, the port does not send
unsolicited IGMP reports or IGMP leave messages.
Static member ports and static router ports never age out. To remove such a port, use the undo
•
igmp-snooping static-group or undo igmp-snooping static-router-port command.
To configure static ports:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet interface
view.
3. Configure the port as a static
member port.
Command
system-view
igmp-snooping
router-aging-time interval
host-aging-time interval
Command
system-view
vlan vlan-id
igmp-snooping
router-aging-time interval
igmp-snooping
host-aging-time interval
Command
system-view
interface interface-type
interface-number
igmp-snooping static-group
group-address [ source-ip
source-address ] vlan vlan-id
20
Remarks
N/A
N/A
The default setting is 260
seconds.
The default setting is 260
seconds.
Remarks
N/A
N/A
The default setting is 260
seconds.
The default setting is 260
seconds.
Remarks
N/A
N/A
By default, a port is not a static
member port.