Configuration Guidelines; Configuration Procedure; Displaying And Maintaining Static Routes; Static Route Configuration Examples - HP MSR2000 series Configuration Manual

Configuration guidelines

FRR takes effect only for static routes that have both an output interface and next hop.
•
Do not use FRR and BFD at the same time.
•

Configuration procedure

To configure static route FRR:
Step
1. Enter system view.
2. Configure the source address
of echo packets.
3. Configure static route FRR.

Displaying and maintaining static routes

Task
Display information of static
routes.
Delete all the static routes.
For more information about the display ip routing-table protocol static [ inactive | verbose ] [ | { begin
| exclude | include } regular-expression ] command, see Layer 3—IP Routing Command Reference.

Static route configuration examples

Basic static route configuration example

Network requirements
Configure static routes in
Command
system-view
bfd echo-source-ip ip-address
ip route-static [ vpn-instance
vpn-instance-name ] fast-reroute
route-policy route-policy-name
Command
display ip routing-table protocol static [ inactive |
verbose ] [ | { begin | exclude | include }
regular-expression ]
delete [ vpn-instance vpn-instance-name ]
static-routes all
Figure 2 for interconnection between any two hosts.
11
Remarks
N/A
Not configured by default.
For more information about this
command, see High Availability
Command Reference.
Not configured by default.
Remarks
Available in any
view
Available in
system view