Configuring Ldp Session Parameters - HP 10500 Series Configuration Manual

Hide thumbs Also See for 10500 Series:
Table of Contents

Advertisement

Step
2.
Enter the view of the interface
where you want to establish
an LDP session.
3.
Configure the Link Hello hold
time.
4.
Configure the Link Hello
interval.
Configuring Targeted Hello timers for an LDP peer
Step
1.
Enter system view.
2.
Enter LDP view.
3.
Specify an LDP peer and enter
LDP peer view. The device will
send unsolicited Targeted
Hellos to the peer and can
respond to the Targeted Hellos
sent from the peer.
4.
Configure the Targeted Hello
hold time.
5.
Configure the Target Hello
interval.

Configuring LDP session parameters

This task configures the following LDP session parameters:
Keepalive hold time and Keepalive interval
LDP transport address—IP address for establishing TCP connections.
LDP uses Basic Discovery and Extended Discovery mechanisms to discovery LDP peers and establish LDP
sessions with them.
When you configure LDP session parameters, follow these guidelines:
The configured LDP transport address must be the IP address of an up interface on the device.
Otherwise, no LDP session can be established.
Make sure the LDP transport addresses of the local and peer LSRs can reach each other. Otherwise,
no TCP connection can be established.
Configuring LDP sessions parameters for Basic Discovery mechanism
To configure parameters for LDP sessions to be established using Basic Discovery mechanism:
Step
1.
Enter system view.
Command
interface interface-type
interface-number
mpls ldp timer hello-hold timeout
mpls ldp timer hello-interval
interval
Command
system-view
mpls ldp
targeted-peer peer-lsr-id
mpls ldp timer hello-hold timeout
mpls ldp timer hello-interval
interval
Command
system-view
65
Remarks
N/A
By default, the Link Hello hold time
is 15 seconds.
By default, the Link Hello interval is
5 seconds.
Remarks
N/A
N/A
By default, the device does not
send Targeted Hellos to or
receive Targeted Hellos from
any peer.
By default, the Targeted Hello
hold time is 45 seconds.
By default, the Targeted Hello
interval is 15 seconds.
Remarks
N/A

Advertisement

Table of Contents
loading

Table of Contents