Operation View - Siemens SITRANS FC430 Operating Instructions Manual

Operating FC430
7.1 Operating instructions
Auto Log Off function
With the "Auto Log Off" function enabled (default), you will be prompted to enter the password
if no keys have been pressed for ten minutes before operating the display again. With the "Auto
Log Off" function disabled, you will not be prompted to enter the password before operating
the HMI.
NOTICE
Device restart
Whenever the device is restarted, the access level is reset to Read Only.
7.1.1.3

Operation view

● The operation view can be displayed in up to six user-configured views. Switch manually
between the enabled views with the keys
to 6) is shown in the upper right corner of the figures below.
The view types including the number of process values shown in the operation view are
configured in HMI menu structure (Page 277).
In view 1 only measurement or diagnostic views can be selected. In views 2 to 6 all view types
can be selected.
Navigation view can only be accessed by pressing the right key in a measurement or a
diagnostic view.
● Measurement views
– Single value
– Three values
– One value and bargraph
– One value and graph
– Six values
● Operating views
– Totalizer
– Dosing
● Alarm view
– Alarm List
● Diagnostic view
– Six Diagnostic Values
In general, all of the HMI views show the following:
122
and . The actual operator view number (1
Operating Instructions, 06/2017, A5E39789392-AA
FC430 (From firmware 4.0)