Siemens SITRANS FC430 Operating Instructions Manual page 147

In order to change the resolution of the process value shown in the operation view (for example
massflow), change the resolution of one configuration parameter for this process value (for
example "Low Flow Cut-off" (menu item 2.2.1.2)). Any changes in resolution will change the
resolution of all configuration parameters for this process value as well.
The resolution can also be changed by setting the decimal places parameter for the selected
process value, for example the decimal places for process value Massflow is defined in
parameter menu item 2.2.1.8.
Numeric parameters read only view
Numeric parameters in read only view are displayed as shown here.
2
1
①
②
③
④
⑤
Figure 7-13
The read only view is shown if you don't have access to edit parameters. The view shows the
set value. Press
FC430 (From firmware 4.0)
Operating Instructions, 06/2017, A5E39789392-AA
3
Escape
The set value
Parameter name
Parameter item number
Help text describing the parameter function.
Numeric parameter read only view
to escape the view.
4
5
Operating FC430
7.2 HMI
147