Siemens SITRANS FC430 Operating Instructions Manual page 35

● Full graphical local display (HMI), with 6 user views and trend curves
● SensorFlash (SD card) for memory backup, logging and documentation storage
(certificates etc.)
● USB service interface
● Hart communication interface (HART 7.5)
● PROFIBUS DP 12 Mbits/s
● PROFIBUS PA profile 4.0
● Modbus RTU RS485
● High immunity against process noise
● Fast response to step changes in flow
● High update rate (100 Hz) on all process values
● Configurable upper and lower alarms and warning limits for process values
● Independent low flow cut-off settings for volume flow and mass flow
● Zero-point adjustment (initiated locally on HMI panel or by host system)
● Process noise damping using digital signal processing (DSP)
● Three totalizers for summation of flow process values
● Simulation of process values
● Empty tube monitoring
● Simulation of outputs
● Simulation of alarms
● Enabling alarms for visibility on all outputs (HMI, status and communication)
● Comprehensive diagnostics (NAMUR or Siemens standard) for troubleshooting and sensor
checking
● Firmware update
● Use in hazardous areas according to specification
● USB mass storage* (not available in the USA)
● Data logging of process values and parameter value change in SensorFlash
● Peak indicators - logging of min & max process peak values with time stamp information
● Alarm delay
● Damping filtering system for process values at HMI or outputs
● Spare part replacement
● Selection of active or passive output signals in none hazardous areas
● Intelligent filtering system for aerated flow
FC430 (From firmware 4.0)
Operating Instructions, 06/2017, A5E39789392-AA
Description
3.2 Features
35