Siemens SITRANS FC430 Operating Instructions Manual page 335

HMI menu ID Parameter
2.2.8.3 Measurement Mode
2.2.7.2 Units
2.2.7.4 Fraction Name
2.2.7.5 Fraction A
2.2.7.5.1 Fraction A Text
2.2.7.5.2 Upper Limit Alarm
2.2.7.5.3 Upper Limit Warning
2.2.7.5.4 Lower Limit Warning
2.2.7.5.5 Lower Limit Alarm
2.2.7.5.6 Alarm Hysteresis
FC430 (From firmware 4.0)
Operating Instructions, 06/2017, A5E39789392-AA
Description
Mass or fraction table is selected Massflow
Select unit for displayed fraction
volume flow rate. Unit is not ap‐
plied at communication inter‐
face.
Name of the selected fraction or
concentration of two-part mix‐
tures or solutions.
Enter a text to describe the Frac‐
tion A.
Set upper alarm limit. Alarm is
triggered if fraction A value is
above the limit.
Set upper warning limit. Warning
is triggered if fraction A value is
above the limit.
Set lower warning limit. Warning
is triggered if fraction A value is
below the limit.
Set lower alarm limit. Alarm is
triggered if fraction A value is be‐
low the limit.
Enter the hysteresis to avoid un‐
wanted rapid switching.
E.3 Standard volume flow
Default value Value range
[unit]
● Massflow
● Volumeflow
m /h l/s, l/min, l/h, l/ d,
3
Ml/d, hl/s, hl/ min,
hl/h, hl/d, m
m /min, m
3
d, Mm /d, gal/s
3
(US), gal/min
(US), gal/h (US),
gal/d (US), Mgal/
d, gal/s (UK), gal/
min (Uk), gal/h
(UK), gal/d (UK),
bbl-beer/s, bbl-
beer/min, bbl-
beer/h, bbl-beer/
d, kbbl/d, Mbbl/d,
bbl (US)/s, bbl
(US)/min, bbl
(US)/h, bbl (US)/
d, ft /s, ft
3
h, ft /d, Mft
3
min, af/h, af/d, in
s, in /min, in
3
in /d, yd3/s, yd
3
min, yd
bu/s, bu/min, bu/
h, bu/d, Custom
1) 1)
1) 1)
1) 1)
1) 1)
1) 1)
Default settings
Access
level
Read
only
User
//s,
3
/h, m /
3 3
/min, ft /
3 3
/d, af/
3
/
3
/h,
3
/
3
/h, yd /d,
3 3
Read
Only
User
User
User
User
User
User
335