Siemens SITRANS FC430 Operating Instructions Manual page 53

4. From the back of the panel:
– Mount mounting bracket on transmitter housing using four hex socket screws (M6 x 60
5. Use four hex head screws (M8 x 100), four hexagon nuts (M8), and two wrenches (13 mm);
and repeat the following for each of the four mounting screws:
– From front side of mounting bracket: Put screw
– From back side of mounting bracket: Screw nut
– Bolt until screw lies against panel wall.
6. Tighten screws.
7. Remount lid.
Opening lid
Care must be taken when opening the lid to avoid the lid falling.
Note
Hygienic applications
If the device is wall or pipe-mounted in a hygienic application, always use domed nuts.
FC430 (From firmware 4.0)
Operating Instructions, 06/2017, A5E39789392-AA
or equivalent), four hexagon nuts (M6) with flanges, a 5 mm Allen key, and a 10 mm
wrench.
CAUTION
Installing/mounting
4.2 Installation instructions
①
into one of the outer holes.
②
on screw.
53