Siemens SITRANS FC430 Operating Instructions Manual page 337

HMI menu ID Parameter
2.2.7.7.4 Lower Limit Alarm
2.2.7.7.5 Hysteresis
2.2.7.7.6 Decimal Places
2.2.7.8 Fraction B %
2.2.7.8.1 Upper Limit Alarm
2.2.7.8.2 Upper Limit Warning
2.2.7.8.3 Lower Limit Warning
2.2.7.8.4 Lower Limit Alarm
2.2.7.8.5 Hysteresis
2.2.7.8.6 Decimal Places
2.2.7.9 Fraction Adjustment
2.2.7.9.1 Adjustment Factor
2.2.7.9.2 Adjustment Offset
: See Sensor dimension dependent default settings (Page 263)
1)
FC430 (From firmware 4.0)
Operating Instructions, 06/2017, A5E39789392-AA
Description
Set lower limit alarm. Alarm is
displayed if fraction A % value is
below the limit.
Enter the hysteresis to avoid un‐
wanted rapid switching.
Define the decimal point for the
process value displayed in the
Local User Interface.
Set upper alarm limit. Alarm is
triggered if fraction B % value is
above the limit.
Set upper warning limit. Warning
is triggered if fraction B % value
is above the limit.
Set lower warning limit. Warning
is triggered if fraction B % value
is below the limit.
Set lower alarm limit. Alarm is
triggered if fraction B % value is
below the limit.
Enter the hysteresis to avoid un‐
wanted rapid switching.
Define the decimal point for the
process value displayed in the
Local User Interface.
Enter the displayed fraction flow
adjustment factor.
Enter the displayed fraction flow
adjustment offset.
E.3 Standard volume flow
Default value Value range
[unit]
0 0.0 to 100.0
[%]
0 0.0 to 100.0
[%]
2 decimal places ● Auto
● No decimal
place
● 1
● 2
● 3
● 4
● 5
● 6
100 0.0 to 100.0
[%]
100 0.0 to 100.0
[%]
0 0.0 to 100.0
[%]
0 0.0 to 100.0
[%]
0 0.0 to 100.0
[%]
2
● Auto
● No decimal
place
● 1
● 2
● 3
● 4
● 5
● 6
1
0
Default settings
Access
level
User
User
User
User
User
User
User
User
User
Expert
Expert
337