Siemens SITRANS FC430 Operating Instructions Manual page 340

Default settings
E.4 Totalizer
HMI menu ID Parameter
2.3.1.10.4 3) Lower alarm limit
2.3.1.10.5 3) Hysteresis
Process Value is set to Mass flow
1)
Process Value is set to Volume flow
2)
Process Value is set to Standard volume flow
3)
Table E-8 Totalizer 2
HMI menu ID Parameter
2.3.2.1 Process value
2.3.2.2 Unit 1)
2.3.2.2 Unit 2)
2.3.2.2 Unit 3)
2.3.2.3 Custom units
2.3.2.4 Custom conversion fac‐
tor
340
Description
Set lower alarm limit. Alarm is
triggered if totalizer 1 value is
above the limit.
Sets the hysteresis for alarm
and warning limits. The hystere‐
sis is the distance between the
limits for activation and deactiva‐
tion of an alarm/warning.
Description
Select process value for totaliza‐
tion.
Select unitss for triggered total‐
izer 2. Units are not applied at
communication interface.
Select unitss for triggered total‐
izer 2. Units are not applied at
communication interface.
Select units for triggered totaliz‐
er 2. Units are not applied at
communication interface.
Define a name for the custom
units. The custom units can then
be selected in the units list.
Define a mass factor for the cus‐
tom units. The factor is based on
SI mass units kg
Default value Value range
[unit]
[normal m3]
0
[normal m3]
Default value Value range
[unit]
Mass flow
● Mass flow
● Volume flow
● Standard
volume flow
● Fraction A
● Fraction B
Kg Kg, t, STon, T, oz,
lb, Custom
L L, hl, m³, gal,
i.ga.,bbl31.5,
bbl31, bbl42, in³,
ft³, yd³, bush, Cus‐
tom
SL Nl, Nm³, SI, Sft³,
Sm³, Custom
Sensor Depend‐
ent
1) 1)
FC430 (From firmware 4.0)
Operating Instructions, 06/2017, A5E39789392-AA
Access
level
User
User
Access
level
User
User
User
User
User
User