E Default Settings - Siemens SITRANS FC430 Operating Instructions Manual

Default settings
The following tables show the default settings as well as the range for various parameters.
The parameters can be accessed on three levels.
● Read Only
Allows no configuration. The user is only able to view the parameter values. No PIN code
required.
● User
Allows configuration and service of all parameters except calibration parameters. Default
PIN code is 2457.
● Expert
Allows configuration and service of all parameters including flow and density calibration
parameters. Default PIN code is 2834.
E.1 Sensor
Table E-1 Sensor
HMI menu ID Parameter
2.1.1 Flow Direction
2.1.2 Process Noise Damping Select process noise damping
2.1.3 Zero point adjustment
2.1.3.1 Select Zero Point Adj.
2.1.3.2 Zero Point Adjustment
2.1.3.3 Duration
FC430 (From firmware 4.0)
Operating Instructions, 06/2017, A5E39789392-AA
Description
Select pos/neg flow. Default pos
flow is indicated by arrow on sen‐
sor.
level.
* 1: Low ... 5: High
Selected zero-point adjustment
method. Automatic zero point
adjustment is recommended.
Wizard
Define zero-point adjustment du‐
ration.
Default value Value range
[unit]
Positive
● Negative
● Positive
Duplex pump (3) ● Centrifugal
pump (1:low)
● Triplex pump
(2)
● Duplex pump
(3)
● Simplex pump
(4)
● Cam pump (5)
high
Auto
● Auto
● Manual
30 1 to 999
[s]
E
Access
level
User
User
User
325