Wizards - Siemens SITRANS FC430 Operating Instructions Manual

Commissioning
6.3 Local commissioning
2
3-4
5
6
7
8-9
*: Pressing Cancel will bypass the Zero Point Adjustment and go to view 10.
Note
View result
Standard Deviation and Offset values are only updated if the zero point adjustment was
completed successfully. Otherwise the previous values are used.
6.3.3.5

Wizards

The HMI wizard graphics show an overview of each HMI wizard and of the keys used to
navigate through the wizards. In the upper left corner of each view the wizard name (for
example "Process Values") and the step name (for example "Unit") of the wizard is shown. In
the upper right corner the view number (for example 5 of 18 in the Process Values wizard) is
shown.
1
2
①
②
③
The purpose of the HMI wizards is to guide you through a quick set-up of various parameters.
The following HMI wizards are available:
● Quick Commissioning
● Process Values
● Zero Point Adjustment
● Inputs/Outputs
● Gas Application
● Pulsating Flow
● Dosing Application
104
Select zero point adjust‐
ment type
Configure
Auto Adjust Zero point
In progress
Result
View result
Wizard name
Step name / Parameter name
View number / Total views in wizard
Auto, Manual
Configure duration and limits
Cancel, Start (progress, result, standard deviation and offset)
The progress bar is shown
Information on success or failure of zero point adjustment
Standard Deviation and Offset values
3
Operating Instructions, 06/2017, A5E39789392-AA
FC430 (From firmware 4.0)