Siemens SITRANS FC430 Operating Instructions Manual page 524

Default settings
E.12 Communication
HMI menu ID Parameter
4.2.8.15 Totalizer 3 unit
4.2.8.15 Totalizer 3 unit
4.2.8.15 Totalizer 3 unit
4.3.9 Damping
4.2.9.1 Damping value
4.2.9.2 Process values (1)
4.3 Modbus (channel 1)
4.3.1 Slave address (SW)
4.3.2 Slave address (HW)
4.3.3 Change Modbus param‐
eters
4.3.4 Data rate
524
Description
Select Totalizer 3 unit for the
communication interface. Unit is
not applied at Local User Inter‐
face.
Select Totalizer 3 unit for the
communication interface. Unit is
not applied at Local User Inter‐
face.
Select Totalizer 3 unit for the
communication interface. Unit is
not applied at Local User Inter‐
face.
Define the damping filter time
constant.
Select the process values for
damping
Enter the device Modbus ad‐
dress. HW address device ad‐
dress overwrites the SW device
address.
Hardware device Modbus ad‐
dress. The HW device address
is configured by DIP switch in
the device.
Changing Modbus parameters
needs restart communication
Select the data rate of your Mod‐
bus network.
Default value Value range
[unit]
kg g, kg, t, lb, STon,
oz, T
L L, hL, m³, Ugal,
BL, BB, BO, in³,
ft³, yd³, gal, bush
SL SL, Nm³, SL, Sft³,
Sm³
0.0 s 0 to 100.0 s
● Mass flow
● Volume flow
● Standard
volume flow
● Standard
density
● Totalizer 1
● Totalizer 2
● Totalizer 3
● Dosing
● Density
● Medium
temperature
1 1 to 247
Cancel
● Cancel
● Ok
19200 Bit/s
● 4800 Bit/s
● 9600 Bit/s
● 38400 Bit/s
● 57600 Bit/s
● 76800 Bit/s
● 115200 Bit/s
FC430 (From firmware 4.0)
Operating Instructions, 06/2017, A5E39789392-AA
Access
level
User
User
User
User
User
User
Read
oSLy
User
User