Service Information - Siemens SITRANS FC430 Operating Instructions Manual

Service and maintenance
9.5 Replacing the device
● HMI Hardware Revision
● Sensor Hardware Revision
9.4.1

Service information

Service information is information about the condition of the device used for diagnostics and
service purposes.
Service information parameters
The basic service information parameters are:
● Driver Current
● Pickup 1 Amplitude
● Pickup 2 Amplitude
● Sensor Frequency
● Frame Temperature
● Process Media Temperature
● Zero Point Adjustment Auto/Manual
● Zero Point Offset Value
● Manual Zero Point
● Zero Point Standard Deviation
9.5 Replacing the device
If the equipment has been used for measuring corrosive substances there is a risk of chemical
burns when disassembling.
Corrosive substances
Risk of chemical burns when replacing the sensor.
The sensor in the device contains corrosive substances that result in burns on unprotected
skin.
● Make sure that the sensor enclosure is not damaged when replacing the sensor.
● If contact with the corrosive substances occurs, rinse the affected skin immediately with
188
CAUTION
large amount of water to dilute substance.
FC430 (From firmware 4.0)
Operating Instructions, 06/2017, A5E39789392-AA