Siemens SITRANS FC430 Operating Instructions Manual page 143

Alarm acknowledgement
There are two ways to have the alarms removed from the alarm list.
● Manual: The alarm remains in the alarm list until the alarm is manually acknowledged (ack.).
The time of the acknowledgement is shown in the history log.
● Auto: The alarm is removed from the alarm list when the cause is removed (going)
Diagnostic view
Six Diagnostic Values
1
2
3
4
5
6
①
②
③
④
⑤
⑥
Fixed display texts
The following table lists the fixed display texts for the process value names available on the
operation view.
Table 7-11
Fixed display text
MASS FLOW
VOL.FLOW
S.VOL FLOW
R.DENSITY
DENSITY
MEDIUM TEMP.
FRACTION A
FC430 (From firmware 4.0)
Operating Instructions, 06/2017, A5E39789392-AA
First process/diagnostic
value
Second process/diag‐
nostic value
Third process/diagnostic
value
Fourth process/diagnos‐
tic value
Fifth process/diagnostic
value
Sixth process/diagnostic
value
Process values
The user-defined process value to be displayed is configured in
menu "View" (1-6) located at "Setup" → "Display"
The user-defined process value to be displayed is configured in
menu "View" (1-6) located at "Setup" → "Display"
The user-defined process value to be displayed is configured in
menu "View" (1-6) located at "Setup" → "Display"
The user-defined process value to be displayed is configured in
menu "View" (1-6) located at "Setup" → "Display"
The user-defined process value to be displayed is configured in
menu "View" (1-6) located at "Setup" → "Display"
The user-defined process value to be displayed is configured in
menu "View" (1-6) located at "Setup" → "Display"
Process value name
Mass flow
Volume flow
Standard Volume flow
Reference Density
Density
Medium Temperature
Fraction A
Operating FC430
7.2 HMI
143