E.10 Resets - Siemens SITRANS FC430 Operating Instructions Manual

Default settings
E.12 Communication
E.10 Resets
Table E-43 Reset
HMI menu ID Parameter
3.11.1 Restore ordered config‐
uration
3.11.2 Device restart
E.11 Firmware update
Table E-44 Firmware update
HMI menu ID Parameter
3.11.1 Firmware update
E.12 Communication
Table E-45 Communication
HMI menu ID Parameter
4.1 Service channel (USB)
4.1.1 USB mode
4.1.2 Auto mode
4.1.3 MSD connect
4.2 HART Channel 1
4.2.1 Polling address (SW)
4.2.2 Polling address (HW)
520
Description
Reset all parameters to custom‐
er ordered settings
Restart the device without dis‐
connecting the power
Description
Update the firmware
Description
Returns the information which
USB mode is currently activated.
Defines if the device is automat‐
ically connected to a PC as MSD
when USB cable is connected.
Connects/disconnects the trans‐
mitter as mass storage device to/
from PC.
Enter the device HART address.
HW address device address
overwrites the SW device ad‐
dress.
Hardware device address. The
HW device address is config‐
ured by DIP switch in the device.
Default value Value range
[unit]
Cancel
● Cancel
● Ok
Cancel
● Cancel
● Ok
Default value Value range
[unit]
Default value Value range
[unit]
USB communi‐
● USB
cation
communicatio
n
● Mass storage
Disabled ● Disabled
● Enabled
Disconnect
● Disconnect
● Connect
0 0 to 63
0 0 to 16
FC430 (From firmware 4.0)
Operating Instructions, 06/2017, A5E39789392-AA
Access
level
User
User
Access
level
Expect
Access
level
User
Read
only