Siemens SITRANS FC430 Operating Instructions Manual page 493

HMI menu ID Parameter
3.4.1.2 Pickup S1 amplitude
3.4.1.3 Pickup S2 amplitude
3.4.1.4 Max. pickup amplitude
diff
3.4.1.5 Sensor frequency
3.4.1.6 Offset
3.4.2 Temperature monitoring
3.4.2.1.1 Current value
3.4.2.2 Transmitter electronics temperature
3.4.2.2.1 Current value
3.4.2.2.2 Minimum
3.4.2.2.3 Timestamp at minimum
3.4.2.2.4 Maximum
3.4.2.2.5 Timestamp at maximum Timestamp when maximum val‐
3.4.2.3 DSL temperature
3.4.2.3.1 Current value
3.4.2.4 Sensor frame temperature
3.4.2.4.1 Current value
3.4.3 Inputs and outputs
3.4.3.1 Channel 1 – output with HART
3.4.3.1.1 Loop Current [mA]
FC430 (From firmware 4.0)
Operating Instructions, 06/2017, A5E39789392-AA
Description
Measured signal level at pick-up
1. The amplitude on pick-up 1
and pick-up 2 should not differ‐
entiate more than 2 mV.
Measured signal level at pick-up
2. The amplitude on pick-up 1
and pick-up 2 should not differ‐
entiate more than 2 mV.
Maximum allowed difference be‐
tween Pickup S1 and Pickup S2.
The resonant frequency of the
sensor. The frequency depends
on sensor size and liquid density.
Zero-point offset compensates
for sensor variation due to proc‐
ess conditions.
The measured medium temper‐
ature in the tube.
The measured internal tempera‐
ture of the transmitter.
Timestamp when minimum val‐
ue was measured
ue was measured
The measured internal tempera‐
ture of the DSL.
The measured temperature of
the sensor frame.
E.9 Maintenance and diagnostics
Default value Value range
[unit]
[mV]
[mV]
[V]
[Hz]
[kg/h]
[°C]
[°C]
[°C]
[°C]
[°C]
[°C]
Default settings
Access
level
Read
only
Read
only
Read
only
Read
only
Read
only
Read
only
Read
only
Read
only
Read
only
Read
only
Read
only
493