IES-1000 User's Guide
5.6.3
Secured Host Delete Command
Syntax:
192.168.1.1 sys> secured host delete <host IP>
where
<host IP>
This command deletes the IP address of a previously added secured host.
5.7
UNIX Syslog Commands
Use UNIX syslog commands to send logs to your UNIX server. If the DSL link is on or goes down, the IES-1000
will send a log to your UNIX server. The table, shown next, indicates what is logged in each case.
5.7.1
Syslog Command
Syntax:
192.168.1.1 sys> syslog [<mode>]
where
<mode>
This command enables or disables the sending of logs to your UNIX server. Syslog is disabled by default
(<mode>= disable). A log is sent if <mode>= enable. To display current settings, do not specify a
<mode>.
5.7.2
Syslog Facility Command
Syntax:
192.168.1.1 sys> syslog facility <facility>
where
<facility>
This command sets the syslog facility for the UNIX system.
5-6
=
The IP address of a secured host.
Table 5-1 Logs Sent to Your UNIX Server
DSL LINK ON
port number
sequence number
rate
If your UNIX server is down these logs will be lost.
=
enable or disable.
=
Local 1 to local 7.
DSL LINK DOWN
port number
sequence number
-
System Commands