Interface Port-Channel Commands; Table 93 Interface Port-Channel Commands - ZyXEL Communications ES-2724 User Manual

39.11.4 interface port-channel Commands

The following table lists the
Use these commands to configure the ports.

Table 93 interface port-channel Commands

COMMAND
interface
port-
channel
<port-
list>
bandwidth-limit
bpdu-control
<peer|tunnel|di
scard|network>
broadcast-limit
diffserv
dlf-limit
egress set
<port-list>
exit
flow-control
Chapter 39 Introducing Commands
interface port-channel
DESCRIPTION
Enables a port or a list of ports for
configuration.
Enables ingress (pir), cir and
egress limits on the port(s).
Enables the guaranteed bandwidth
cir
limits for incoming traffic on the
port(s).
Sets the guaranteed bandwidth
cir <Kbps>
allowed for incoming traffic on the
port(s).
Enables bandwidth limits allowed
pir
for incoming traffic on the port(s).
Sets the maximum bandwidth
pir <Kbps>
allowed for incoming traffic on the
port(s).
Enables bandwidth limits allowed
egress
for outgoing traffic on the port(s).
Sets the maximum bandwidth
egress <Kbps>
allowed for outgoing traffic on the
port(s).
Sets how Bridge Protocol Data
Units (BPDUs) are used in STP
port states.
Enables broadcast storm control
limit on the switch.
Enables DiffServ on the port(s).
Enables the Destination Lookup
Failure (DLF) limit.
Sets the interface DLF limit in
<pkt/s>
packets per second (pps).
Sets the outgoing traffic port list for
a port-based VLAN.
Exits from the interface port-
channel command mode.
Enables interface flow control.
Flow control regulates
transmissions to match the
bandwidth of the receiving port.
ES-2724 User's Guide
commands in configuration mode.
PRIVILEGE
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
259