Interface Port-Channel Commands; Table 142 Interface Port-Channel Commands - ZyXEL Communications ZyXEL Dimension ES-4124 User Manual

Table 141 Command Summary: Configuration Mode (continued)
COMMAND
<SPTPID>
vlan-type <802.1q|port-
based>
wfq
wrr

45.12.4 interface port-channel Commands

The following table lists the
Use these commands to configure the ports.

Table 142 interface port-channel Commands

COMMAND
interface
port-
channel
<port-
list>
arp inspection
bandwidth-limit
ES-4124 User's Guide
DESCRIPTION
Sets the SP TPID (Service
Provider Tag Protocol Identifier).
Specifies the VLAN type.
Sets the queuing method to
WFQ (Weighted Fair Queuing).
Sets the queuing method to
WRR (Weighted Round Robin).
interface port-channel
DESCRIPTION
Enables a port or a list of ports for
configuration.
Sets the port to be a trusted port
trust
for arp inspection. The Switch
does not discard ARP packets on
trusted ports for any reason.
Specifies the maximum rate (1-
limit rate <pps>
2048 packets per second) at
which the Switch receives ARP
packets from each port. The
Switch discards any additional
ARP packets. Enter 0 to disable
this limit.
Specifies the length (1-15
limit rate <pps>
seconds) of the burst interval.
burst interval
The burst interval is the length of
<seconds>
time over which the rate of ARP
packets is monitored for each
port.
Enables ingress (pir), cir and
egress limits on the port(s).
Enables the guaranteed
cir
bandwidth limits for incoming
traffic on the port(s).
Sets the guaranteed bandwidth
cir <Kbps>
allowed for incoming traffic on the
port(s).
Enables bandwidth limits allowed
pir
for incoming traffic on the port(s).
Sets the maximum bandwidth
pir <Kbps>
allowed for incoming traffic on the
port(s).
Chapter 45 Introducing Commands
PRIVILEGE
13
13
13
13
commands in configuration mode.
PRIVILEGE
13
13
13
13
13
13
13
13
13
375