Setting The Destination Address Of The Statistics - Huawei S9700 Series Configuration Manual

S9700 Core Routing Switch
Configuration Guide - SPU
The XGigabitEthernet interface view is displayed.
Step 3 (Optional) Run:
ip netstream sampler { fix-packets packet-interval | random-packets packet-
interval | fix-time time-interval | random-time time-interval } inbound
The packet sampling ratio is set on the XGigabitEthernet interface.
By default, the packet sampling ratio on the XGigabitEthernet interface is 1.
Step 4 Run:
ipv6 netstream inbound
The NetStream function is enabled on the interface to collect statistics about IPv6 unicast traffic.
By default, NetStream is disabled for the IPv6 traffic.
Currently, NetStream can be enabled only on XGigabitEthernet 0/0/1.
----End

5.4.3 Setting the Destination Address of the Statistics

Context
NetStream statistics can be sent to the NSC only if source and destination addresses are
configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 (Optional) Run:
ipv6 netstream export source ip-address
The source address for exporting statistics is configured.
By default, the source address of the exported packets carrying the NetStream statistics is
0.0.0.0.
Step 3 Run:
ipv6 netstream export host ip-address port-number
The destination IP address of the exported statistics, that is, the IP address of the NSC, is
configured.
If multiple destination addresses are configured, the statistics are exported to multiple NSCs.
You can configure up to 2 destination addresses to implement the backup between 2 NSCs.
----End
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 NetStream Configuration
154