Table of Contents
Advertisement
S9700 Core Routing Switch
Configuration Guide - SPU
Step 11 (Optional) Run:
destination port port-number
The destination port number of a probe is configured.
By default, the destination port number of a probe is the port number of a load balancing member
instance through the member port port-number command. If the port number of a load balancing
member instance is not configured, the destination port number of a probe is the default port
number. For example, TCP and HTTP probes use destination port 80 and UDP probes use
destination port 53. ICMP probes have no destination port number.
If a TCP probe, a UDP probe, or an HTTP probe is bound to a load balancing group, the
destination port number of the probe cannot be changed.
----End
6.4.4 Configuring a Server
This section describes how to set the IP address and related parameters for each server on the
SPU so that the SPU can communicate with each server.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
load-balance member member-name
A server is created and the load balancing member view is displayed.
Up to 1024 servers can be created.
Issue 01 (2012-03-15)
The HTTP request method and the URL used by the HTTP probe are configured.
The difference between the GET method and Head method is as follows: the entire page
corresponding to the URL is obtained by using the GET method, whereas the header of
the corresponding to the URL is obtained by using the Head method.
By default, the HTTP request method is GET and no URL is used.
– Run:
user user-name [ password
The user name and password of an HTTP request are set.
By default, the user name and password of an HTTP request are not set.
– Run:
header { accept | accept-charset } header-value value
The Accept field or the Accept-Charset field in an HTTP request packet header is set.
By default, the SPU does not set the Accept field or the Accept-Charset field in an HTTP
request packet header.
– Run:
expect status-code min min-number max max-number
The range of the expected return status code is set.
By default, the expected return status code is 200.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
password ]
6 Load Balancing Configuration
211
Advertisement
Table of Contents
