Huawei S9700 Series Configuration Manual page 23

Terabit routing switches spu
Hide thumbs Also See for S9700 Series:
Table of Contents

Advertisement

S9700 Core Routing Switch
Configuration Guide - SPU
3.
4.
5.
6.
7.
8.
9.
----End
Issue 01 (2012-03-15)
Exit from the VLAN view.
Run:
interface interface-type interface-number
The view of the interface that forwards the traffic processed by the SPU to the LPU is
displayed.
Run:
port link-type { access | hybrid | trunk
The link type of the interface is configured.
Run any of the following commands to add the interface to the VLAN based on the link
type of the interface:
l If the interface is an access interface, run the port default vlan vlan-id command to
configure the VLAN as the default VLAN of the interface.
l If the interface is a hybrid interface:
– Run the port hybrid tagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command to
add the interface to the VLAN in tagged mode.
– Run the port hybrid untagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command
to add the interface to the VLAN in untagged mode.
l If the interface is a trunk interface, run the port trunk allow-pass vlan { { vlan-id1
[ to vlan-id2 ] }&<1-10> | all command to add the interface to the VLAN.
Run:
quit
Exit from the interface view.
Run:
interface xgigabitethernet interface-number
The view of the virtual XGE interface on the S9700 is displayed.
Run any of the following commands to add the interface to the VLAN based on the link
type of the interface:
l If the interface is an access interface, run the port default vlan vlan-id command to
configure the VLAN as the default VLAN of the interface.
l If the interface is a hybrid interface:
– Run the port hybrid tagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command to
add the interface to the VLAN in tagged mode.
– Run the port hybrid untagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command
to add the interface to the VLAN in untagged mode.
l If the interface is a trunk interface, run the port trunk allow-pass vlan { { vlan-id1
[ to vlan-id2 ] }&<1-10> | all command to add the interface to the VLAN.
Run:
quit
Exit from the interface view.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SPU Pre-Configuration
12

Advertisement

Table of Contents
loading

Table of Contents