Table of Contents
Advertisement
S9700 Core Routing Switch
Configuration Guide - SPU
11. Run:
12. Run:
13. Run:
14. Run:
15. Run:
16. Run:
Step 2 Export data flows.
1.
2.
Step 3 Configure an Eth-Trunk:
1.
2.
3.
Issue 01 (2012-03-15)
Exit from the interface view.
vlan vlan-id
The VLAN for incoming data flows is created and the VLAN view is displayed.
quit
Exit from the VLAN view.
interface vlanif vlan-id
A VLANIF interface is created and the VLANIF interface view is displayed. The value of
vlan-id must be the same as the VLAN ID specified in
ip address ip-address { mask| mask-length}
An IP address is configured for the VLANIF interface.
quit
Exit from the VLANIF interface view.
ip route-static ip-address { mask | mask-length } vlanif vlan-id [ nexthop-
address ]
The static route to the destination IP address of traffic is configured. Here, ip-address
indicates the destination IP address; mask or mask-length indicates the mask of the
destination IP address; vlan-id indicates the VLAN ID created in
address indicates the IP address of the VLANIF interface on the SPU, which is configured
in
Step 2.4
of section "Configuring Layer 3 Flow Import on the SPU with Interfaces
Aggregated."
Run:
vlan vlan-id
An outbound VLAN is created and the VLAN view is displayed.
Run:
quit
Exit from the VLAN view.
Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
Run:
trunkport xgigabitethernet { interface-number1 [ to interface-number2 ] }
&<1-8>
Two virtual interfaces on the S9700 are aggregated as the Eth-Trunk interface.
Run:
port link-type { access | hybrid | trunk }
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SPU Pre-Configuration
Step
1.11.
Step
1.11; nexthop-
18
Advertisement
Table of Contents
