S9700 Core Routing Switch
Configuration Guide - SPU
Procedure
Step 1 Run the display ip netstream all command to view the NetStream configuration.
----End
5.6 Configuring the Aggregation Statistics About Traffic
This section describes how to configure the statistics about IPv4 and MPLS aggregation traffic
passing an interface.
5.6.1 Establishing the Configuration Task
Applicable Environment
When the NetStream function is configured, a mode of collecting statistics about aggregation
traffic must be configured to classify statistics about packets according to certain rules.
Pre-configuration Tasks
Before configuring NetStream for aggregation traffic, complete the following tasks:
l
l
l
Data Preparation
To configure NetStream, you need the following data.
No.
1
2
3
5.6.2 Enabling NetStream on an Interface
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface xgigabitethernet interface-number
Issue 01 (2012-03-15)
Setting physical parameters on an interface
Setting the link-layer parameters of the interface
Configuring port mirroring on the Switch to import the flows to the SPU
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 NetStream Configuration
Data
Name and number of the interface on which
traffic statistics need to be collected
Version number of exported packets
IP address and port number of the NSC
160