Collecting Ipv6 Traffic Statistics; Establishing The Configuration Task; Enabling Netstream On An Interface - Huawei S9700 Series Configuration Manual

S9700 Core Routing Switch
Configuration Guide - SPU
Procedure
Step 1 Run the display ip netstream all command to view the NetStream configuration.
----End

5.4 Collecting IPv6 Traffic Statistics

This section describes how to collect statistics about IPv6 traffic passing through an interface.

5.4.1 Establishing the Configuration Task

Applicable Environment
To collect statistics about incoming and outgoing IPv6 packets on an interface, configure the
NetStream for IPv6 original traffic. The statistics result is sent to the Network Management
System (NMS). By analyzing the traffic statistics, the NMS obtains the traffic information for
you to effectively manage the network.
Pre-configuration Tasks
Before configuring NetStream for IPv6 original traffic, complete the following tasks:
l
l
l
Data Preparation
To configure NetStream, you need the following data.
No.
1
2
3

5.4.2 Enabling NetStream on an Interface

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface xgigabitethernet interface-number
Issue 01 (2012-03-15)
Setting physical parameters on an interface
Setting the link-layer parameters of the interface
Configuring port mirroring on the Switch to import the flows to the SPU
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 NetStream Configuration
Data
Name and number of the interface on which
traffic statistics need to be collected
Version of the exported packets
IP address and port number of the NSC
153