Optional) Configuring The Inactive Aging Time For The Aggregation Traffic; Optional) Configuring The Active Aging Time For The Aggregation Traffic; Checking The Configuration - Huawei S9700 Series Configuration Manual

S9700 Core Routing Switch
Configuration Guide - SPU
----End
5.6.6 (Optional) Configuring the Inactive Aging Time for the
Aggregation Traffic
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip netstream aggregation timeout inactive inactive-interval
The inactive aging time is set for the aggregation traffic.
By default, the inactive aging time of the aggregation traffic is 30s.
----End
5.6.7 (Optional) Configuring the Active Aging Time for the
Aggregation Traffic
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip netstream aggregation timeout active active-interval
The active aging time is set for the aggregation traffic.
By default, the active aging time of the aggregation traffic is 30 minutes.
----End

5.6.8 Checking the Configuration

Prerequisites
The NetStream configuration is complete.
Procedure
Step 1 Run the display ip netstream all command to view the NetStream configuration.
----End
Issue 01 (2012-03-15)
If no destination NSC address is configured in the NetStream aggregation view, aggregation
traffic is sent to the destination NSC address configured in the system view.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 NetStream Configuration
163