Optional) Configuring The Export Of Statistics - Huawei S9700 Series Configuration Manual

S9700 Core Routing Switch
Configuration Guide - SPU
Step 2 Run:
ip netstream aggregation { as | as-tos | destination-prefix | destination-prefix-
tos | mpls-label | prefix | prefix-tos | protocol-port | protocol-port-tos | source-
prefix | source-prefix-tos }
The NetStream aggregation view is displayed.
Step 3 (Optional) Run:
export version version
The version of the exported packets is configured.
By default, the version of the exported packets is V8.
----End

5.6.5 (Optional) Configuring the Export of Statistics

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip netstream aggregation { as | as-tos | destination-prefix | destination-prefix-
tos | mpls-label | prefix | prefix-tos | protocol-port | protocol-port-tos | source-
prefix | source-prefix-tos }
The NetStream aggregation view is displayed.
Step 3 (Optional) Run:
ip netstream export source ip-address
The source address for exporting statistics is configured.
Step 4 (Optional) Run:
ip netstream export host ip-address port-number
The destination address for exporting statistics is configured.
The destination NSC address of the exported statistics can be configured in either the system
view or the NetStream aggregation view.
The priority of the destination NSC address configured in the NetStream aggregation view is
higher than that configured in the system view. After the destination NSC address is successfully
configured,
l Original traffic can only be sent to the destination NSC address configured in the system
l Aggregation traffic is sent to the destination NSC address configured in the NetStream
Issue 01 (2012-03-15)
NOTE
When the mpls-label mode is enabled, the version of exported packets cannot be set. The default version
V9 is used.
view.
aggregation view.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 NetStream Configuration
162