Table of Contents
Advertisement
S9700 Core Routing Switch
Configuration Guide - SPU
16. Run:
17. Run:
18. Run any of the following commands to add the interface to the VLAN based on the link
19. Run:
20. Run:
Step 2 Export data flows.
1.
2.
3.
4.
Issue 01 (2012-03-15)
interface xgigabitethernet interface-number
The view of the virtual XGE interface is displayed.
port link-type { access | hybrid | trunk }
The link type of the interface is configured.
type of the interface:
l If the interface is an access interface, run the port default vlan vlan-id command to
configure the VLAN as the default VLAN of the interface.
l If the interface is a hybrid interface:
– Run the port hybrid tagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command to
add the interface to the VLAN in tagged mode.
– Run the port hybrid untagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command
to add the interface to the VLAN in untagged mode.
l If the interface is a trunk interface, run the port trunk allow-pass vlan { { vlan-id1
[ to vlan-id2 ] }&<1-10> | all command to add the interface to the VLAN.
quit
Exit from the XGE interface view.
ip route-static ip-address { mask | mask-length } vlanif vlan-id [ nexthop-
address ]
The static route to the destination IP address of traffic is configured. Here, ip-address
indicates the destination IP address; mask or mask-length indicates the mask of the
destination IP address; vlan-id indicates the VLAN created in
address indicates the IP address of the VLANIF interface on the SPU, which is configured
in
Step 1.5
of section "Configuring Layer 3 Flow Import on the SPU Without Interface
Aggregation."
Run:
vlan vlan-id
The VLAN for outgoing data flows is created and the VLAN view is displayed.
Run:
quit
Exit from the VLAN view.
Run:
interface xgigabitethernet interface-number
The virtual XGE interface view is displayed.
Run any of the following commands to add the interface to the VLAN based on the link
type of the interface:
l If the interface is an access interface, run the port default vlan vlan-id command to
configure the VLAN as the default VLAN of the interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SPU Pre-Configuration
Step
1.11; nexthop-
23
Advertisement
Table of Contents
