Table of Contents
Advertisement
S9700 Core Routing Switch
Configuration Guide - SPU
Procedure
Step 1 Import data flows.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Run:
Issue 01 (2012-03-15)
Run:
system-view
The system view is displayed.
Run:
vlan vlan-id
A VLAN is created and the VLAN view is displayed.
Run:
quit
Exit from the VLAN view.
Run:
interface vlanif vlan-id
A VLANIF interface is created and the VLANIF interface view is displayed. The value of
vlan-id must be the same as the VLAN ID specified in
Run:
ip address ip-address { mask| mask-length}
An IP address is configured for the VLANIF interface. This IP address is on the same
network segment as the source IP address of the traffic.
Run:
quit
Exit from the VLANIF interface view.
Run:
interface interface-type interface-number
The view of the interface that forwards traffic to the SPU is displayed.
Run:
port link-type { access | hybrid | trunk }
The link type of the interface is configured.
Run any of the following commands to add the interface to the VLAN based on the link
type of the interface:
l If the interface is an access interface, run the port default vlan vlan-id command to
configure the VLAN as the default VLAN of the interface.
l If the interface is a hybrid interface:
– Run the port hybrid tagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command to
add the interface to the VLAN in tagged mode.
– Run the port hybrid untagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command
to add the interface to the VLAN in untagged mode.
l If the interface is a trunk interface, run the port trunk allow-pass vlan { { vlan-id1
[ to vlan-id2 ] }&<1-10> | all command to add the interface to the VLAN.
quit
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SPU Pre-Configuration
Step
1.2.
17
Advertisement
Table of Contents
