Table of Contents
Advertisement
S9700 Core Routing Switch
Configuration Guide - SPU
4.
Step 2 Import data flows.
1.
2.
3.
4.
5.
6.
Step 3 Export data flows.
1.
2.
3.
Issue 01 (2012-03-15)
Run:
quit
Exit from the Eth-Trunk interface view.
Run:
interface eth-trunk trunk-id.subtrunk-id
The Eth-Trunk sub-interface view is displayed. Traffic is imported to the SPU through the
Eth-Trunk sub-interface.
Run:
control-vid vid dot1q-termination
The VLAN to which the sub-interface belongs is specified, and the encapsulation mode of
the sub-interface is configured.
Run:
dot1q termination vid low-pe-vid [ to high-pe-vid ]
The sub-interface is configured to allow the VLAN for incoming data flows. The VLAN
is configured in
Step 1.2
with Interfaces Aggregated."
Run:
ip address ip-address { mask | mask-length } [ sub ]
An IP address is configured for the Eth-Trunk sub-interface.
Run:
arp broadcast enable
The ARP broadcast function is enabled on the Eth-Trunk sub-interface.
When you enable or disable the ARP broadcast function on a sub-interface, the routing
status on the sub-interface becomes Down and then Up. This may result in route flapping
on the entire network, affecting the service operation.
Run:
quit
Exit from the Eth-Trunk sub-interface view.
Run:
interface eth-trunk trunk-id.subtrunk-id
The Eth-Trunk sub-interface view is displayed. Traffic is exported from the SPU through
the Eth-Trunk sub-interface.
Run:
control-vid vid dot1q-termination
The VLAN and the encapsulation mode of the sub-interface are configured.
Run:
dot1q termination vid low-pe-vid [ to high-pe-vid ]
The sub-interface is configured to allow the VLAN for outgoing data flows. This VLAN
is configured in
Step 2.1
with Interfaces Aggregated."
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
of section "Configuring Layer 2 Flow Import on the S9700 Switch
of section "Configuring Layer 2 Flow Import on the S9700 Switch
1 SPU Pre-Configuration
9
Advertisement
Table of Contents
