Table of Contents
Advertisement
S9700 Core Routing Switch
Configuration Guide - SPU
4.
5.
6.
7.
8.
9.
Data Preparation
To complete the configuration, you need the following data
l
l
l
l
l
Procedure
Step 1 Check the service type of the SPUs.
# Log in to SPU A and SPU B to check whether the service type of SPU A and SPU B is the
firewall service in the system view.
<SPU> system-view
[SPU] display service-type
The service type is Firewall!
# If yes, proceed to the next step. If not, change the service type of SPU A and SPU B to the
firewall service, and then restart SPU A and SPU B after the change.
[SPU] set service-type firewall
The service type will be available after you restart the board, please restart!
Step 2 Configure interfaces of the LPU.
# Log in to the MPU to create VLAN 10, VLAN 11, and VLAN 13, configure VLANIF 18 on
GE 2/0/10 of the LPU, and set parameters of GE 2/0/10 and GE 2/0/11. Then bind XGE 3/0/0
and XGE 3/0/1 of the MPU to Eth-Trunk 0, and bind XGE 5/0/0 and XGE 5/0/1 of the MPU to
Eth-Trunk 1.
[MPU] vlan 10
[MPU-VLAN10] quit
[MPU] vlan 11
[MPU-VLAN11] quit
[MPU] vlan 13
[MPU-VLAN13] quit
[MPU] vlan 18
[MPU-VLAN18] quit
[MPU] interface vlanif 18
[MPU-Vlanif18] ip address 18.0.0.1 24
[MPU-Vlanif18] quit
Issue 01 (2012-03-15)
Configure interfaces of SPUs.
Configure VRRP.
Configure static routes on SPUs.
Configure dual-system HSB between SPU A and SPU B.
Check whether VRRP negotiation is correct and whether the channel through which dual-
system HSB data is synchronized is set up successfully.
Save the configuration.
GE interfaces, VLAN IDs, VLANIF interfaces, and IP addresses of the LPU
XGE interfaces, VLAN IDs, VLANIF interfaces, IP addresses, and bound Eth-Trunks of
the MPU
XGE interfaces, IP addresses, bound Eth-Trunks, and dot1q values of SPU A
XGE interfaces, IP addresses, bound Eth-Trunks, and dot1q values of SPU B
ID and virtual IP address of the VRRP backup group and priorities of SPU A and SPU B
NOTE
By default, GE 2/0/10, GE 2/0/11, XGE 3/0/0, XGE 3/0/1, XGE 5/0/0, and XGE 5/0/1 allow packets of
VLAN 1 to pass through.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Dual-System HSB Configuration
(Figure 7-2
shows the detailed data):
307
Advertisement
Table of Contents
