Associating An Acl With An Address Pool; Configuring Easy Ip - Huawei S9700 Series Configuration Manual

S9700 Core Routing Switch
Configuration Guide - SPU
By default, no public address pool is configured on the SPU.
----End

3.3.3 Associating an ACL with an Address Pool

Network administrators can use ACLs to control which users can access public networks using
NAT.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number.subnumber
The interface view is displayed.
Step 3 Run:
nat outbound acl-number [ address-group group-index [ no-pat ] | interface
loopback interface-number ]
An ACL is associated with an address pool.
After an ACL is associated with an address pool, the SPU translates source addresses of data
packets matching the ACL to an IP address in the address pool. Different IP address translation
entries can be configured on an interface.
In the command, no-pat indicates one-to-one NAT, that is, only the IP address is translated and
the port number is not translated
----End

3.3.4 Configuring Easy IP

Easy IP uses an interface IP address as the source address of data packets matching an ACL.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
nat outbound acl-number [ address-group group-index [ no-pat ] ]
Easy IP is configured.
----End
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 NAT Configuration
91