Table of Contents
Advertisement
S9700 Core Routing Switch
Configuration Guide - SPU
2.
3.
4.
----End
Configuring Layer 2 Flow Import on the SPU with Interfaces Aggregated
This section describes how to configure Layer 2 flow import on the SPU in interface aggregation
mode.
Context
Procedure
Step 1 Configure an Eth-Trunk.
1.
2.
3.
Issue 01 (2012-03-15)
The Eth-Trunk interface view is displayed.
Run:
trunkport xgigabitethernet { interface-number1 [ to interface-number2 ] }
&<1-8>
Two virtual interfaces are configured as member interfaces of the Eth-Trunk interface.
Run:
port link-type { access | hybrid | trunk }
The link type of the Eth-Trunk interface is configured.
Run any of the commands to add the Eth-Trunk interface to the VLANs for incoming and
outgoing data flows based on the link type of the Eth-Trunk interface:
l If the interface is an access interface, run the port default vlan vlan-id command to
configure the VLAN as the default VLAN of the interface.
l If the interface is a hybrid interface:
– Run the port hybrid tagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command to
add the interface to the VLAN in tagged mode.
– Run the port hybrid untagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command
to add the interface to the VLAN in untagged mode.
l If the interface is a trunk interface, run the port trunk allow-pass vlan { { vlan-id1
[ to vlan-id2 ] }&<1-10> | all command to add the interface to the VLAN.
NOTE
In this document, incoming data flows refer to the flows sent from an LPU to the SPU, and outgoing data
flows refer to the flows sent from the SPU to an LPU.
Run:
system-view
The system view is displayed.
Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
Run:
trunkport xgigabitethernet { interface-number1 [ to interface-number2 ] }
&<1-8>
Two virtual interfaces are configured as member interfaces of the Eth-Trunk interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SPU Pre-Configuration
8
Advertisement
Table of Contents
