Set Logout - Enterasys N Standalone (NSA) Series Configuration Manual

2.2.3.32

set logout

Use this command to set the time (in minutes) an idle console or Telnet CLI session will remain
connected before timing out.
set logout timeout
Syntax Description
timeout
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the system timeout to 10 minutes:
Matrix(rw)->set logout 10
Sets the number of minutes the system will remain idle
before timing out.
Matrix NSA Series Configuration Guide
General Configuration Command Set
Setting Basic Device Properties
2-81