Mitsubishi Electric MELSEC iQ-R Series Programming Manual page 452

■Setting method of (s) for when SM705 (Number of conversion digits selection) is on
Set hexadecimal ASCII data with a desired number of digits (including 00H (NULL code)) in (s). Note that 00H (NULL code) is
not required to be set for the maximum number of digits (8 digits).
The following table lists the setting method of (s).
Value to be set Data of (s) to (s)+3
in (s)
• 0H to FH • Set 00H in the upper byte of (s).
• The data of (s)+1 or later is ignored.
(s)
(s)+1
(s)+2
(s)+3

• 1000000H to • Set 00H in the upper byte of (s)+3.
FFFFFFFH • The data of (s)+4 or later is ignored.
(s)
(s)+1
(s)+2
(s)+3
ASCII : ASCII code (th digit)
• The ASCII data in the device specified by (s) to (s)+3 is within the range from 00000000H to FFFFFFFFH.
• The data of (s)+4 or later is ignored.
• A value from 30H to 39H and 41H to 46H can be set in each place of ASCII code.
• If a value 00H is set in each place of ASCII code, the value will be processed as the end of the hexadecimal ASCII data.
Operation error
Error code Description
(SD0)
3401H Invalid data that cannot be converted are input in (s) to (s)+3.
• A value in each place of ASCII code is other than "30H" to "39H" and "41H" to "46H".
6 BASIC INSTRUCTIONS
450
6.6 Data Conversion Instructions
b15 ∙∙∙ b8 b7
00H ASCII 1
b15 ∙∙∙ b8 b7
ASCII 6 ASCII 7
ASCII 4 ASCII 5
ASCII 2 ASCII 3
00H ASCII 1
Value to be set
in (s)
• 10H to FFH
∙∙∙ b0
• 10000000H to
FFFFFFFFH
∙∙∙ b0
Data of (s) to (s)+3
• Set 00H in the lower byte of (s)+1.
• The data of the upper byte of (s)+1 or later is
ignored.
b15 ∙∙∙ b8 b7
(s)
ASCII 1
(s)+1
(s)+2
(s)+3
• The data of (s)+4 or later is ignored.
b15 ∙∙∙ b8 b7
(s)
ASCII 7
(s)+1
ASCII 5
(s)+2
ASCII 3
(s)+3
ASCII 1
∙∙∙ b0
ASCII 2
00H
∙∙∙ b0
ASCII 8
ASCII 6
ASCII 4
ASCII 2