Mitsubishi Electric MELSEC iQ-R Series Programming Manual page 454

Processing details
• These instructions convert the decimal ASCII data stored in the device areas specified by (s) and later to BCD 4-digit data,
and store the converted data in the device specified by (d).
• The setting method of the decimal ASCII data to be set in (s) depends on the status of SM705 (Number of conversion digits
selection).
*1
Status of SM705
OFF
ON
*1 For the firmware version of the CPU module supporting SM705, refer to the following.
 MELSEC iQ-R CPU Module User's Manual (Application)
A CPU module which does not support SM705 operates in the same way as SM705 is off even if it is turned on.
■Setting method of (s) for when SM705 (Number of conversion digits selection) is off
• Set decimal ASCII data the 4 digits (fixed) in (s) to (s)+1.
b15 ∙∙∙
(s)
ASCII 10 2
(s)+1
ASCII 10 0
3
ASCII 10 : Thousands place of ASCII code
2
ASCII 10 : Hundreds place of ASCII code
1
ASCII 10 : Tens place of ASCII code
0
ASCII 10 : Ones place of ASCII code
• The ASCII data in the device specified by (s) to (s)+1 is within the range from 0 to 9999.
• The data of (s)+2 or later is ignored.
• A value from 30H to 39H can be set in each place of ASCII code.
• If a value 20H or 00H is set in each place of ASCII code, the value will be processed as 30H.
Ex.
When 8765 is specified in (s)
b15 ∙∙∙
(s)
37H (7)
(s)+1
35H (5)
6 BASIC INSTRUCTIONS
452
6.6 Data Conversion Instructions
Setting method of (s)
Set (s) with a fixed number of digits (4 digits).
Set (s) with a desired number of digits (maximum: 4
digits).
b8 b7 ∙∙∙ b0
3
ASCII 10
1
ASCII 10
b8 b7 ∙∙∙ b0
38H (8)
36H (6)
Reference
Page 452 Setting method of (s) for when SM705 (Number of conversion
digits selection) is off
Page 453 Setting method of (s) for when SM705 (Number of conversion
digits selection) is on
b15 ∙∙∙ b12 b11 ∙∙∙ b8 b7 ∙∙∙
(d)
×10 ×10 ×10
3 2
b15 ∙∙∙ b12 b11 ∙∙∙ b8 b7 ∙∙∙
(d)
8 7 6
b4 b3 ∙∙∙ b0
×10
1 0
b4 b3 ∙∙∙ b0
5