Mitsubishi Electric MELSEC iQ-R Series Programming Manual page 576

■Applicable devices
Operand Bit
X, Y, M, L,
SM, F, B, SB,
FX, FY
(File name) 

(P)
*1
(s1)(s5) 
*1 Any value other than F can be used.
Processing details
• When the EFCALL(P) instruction is executed, these instructions perform non-execution processing
program of the pointer specified by (P). The EFCALL(P) instructions can also call the subroutine program using the local
pointer of another program file.
*2 Non-execution processing is the same as the processing performed by each coil instruction with the condition contact set to off.
[File name: MAIN]
Main routine program
EFCALL ʺABCʺ (P)
END
• The operation results of individual coil instructions after the end of non-execution processing are as follows regardless of
on/off of the condition contact.
Device used for operation
High-speed timer, low-speed timer
High-speed retentive timer, low-speed retentive timer, counter
Device in OUT instruction
Device in the SET, RST, SFT(P), or basic/application instruction
PLS or pulse instruction (P)
7 APPLICATION INSTRUCTIONS
574
7.4 Structure Creation Instructions
Word
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
 
 
 
[File name: ABC]
Subroutine program
(P)
RET
Double word Indirect
U\G, J\, Z LT, LST,
U3E\(H)G LC
  
  
  
(1) Non-execution processing is performed when the command of the
EFCALL(P) instruction changes from on to off.
(1)
Operation result (device status)
Set to 0
Maintains the current status.
Forcibly turned off.
Maintains the current status.
Performs the same processing as when the condition contact
is off.
Constant
specification
LZ K, H E
   
   
   
*2
of the subroutine
Others
(P)
$
 
 
 