Installing A Brake Relay - Pm250 Power Module - Siemens SINAMICS G120 Operating Instructions Manual

Low voltage converters chassis devices with cu240b-2 and cu240e-2

Hide thumbs Also See for SINAMICS G120:

Table of Contents

Installing a Brake Relay - PM250 Power Module

Installing the Brake Relay

If you use the optional shield plate, install the Brake Relay on the shield plate of the Power

If you do not use the shield plate, install the Brake Relay as close as possible to the Power

Connecting the Brake Relay to the inverter

The connector for the Brake relay is located at the front of the Power Module for the FSA ...

FSC frame sizes. These Power Modules have a cable entry for the connecting cable to the

Brake Relay.

The connector for the Brake Relay is located at the bottom of the Power Module for the FSD

... FSF frame sizes.

Converter with the CU240B-2 and CU240E-2 Control Units

Operating Instructions, 01/2017, FW V4.7 SP6, A5E34259001B AD

4.4 Connecting the line supply, motor, and inverter components