Firmware Version 4.7; A.1.3 Firmware Version 4.7 - Siemens SINAMICS G120 Operating Instructions Manual

Appendix
A.1 New and extended functions
A.1.3

Firmware version 4.7

Table A-3 New functions and function changes in Firmware 4.7
Function
1 Supporting the identification & maintenance datasets (I&M1 ... 4)
2 Fall in pulse rate with increased drive power required by the motor
● The inverter temporarily lowers the pulse frequency if required when the
motor is started up, and simultaneously increases the current limit.
3 S7 communication
● Direct data exchange between the inverter and human-machine interface
(HMI).
● Increase in communication performance with the engineering tools and
support of the S7 routing
4 The basic functions of Safety Integrated are unrestrictedly available in all control
types with 1FK7 encoderless permanent-field synchronous motors
5 Direct selection of the 1FK7 encoderless permanent-field synchronous motors
using the Article No. with allocated code number
● It is not necessary to input individual motor data
6 Pulse input as source of setpoint value
● The inverter calculates its speed setpoint from a sequence of pulses at the
digital input.
7 Dynamic IP address assignment (DHCP) and temporary device names for
PROFINET
8 PROFIenergy Slave profile 2 and 3
9 Uniform behavior for component replacement
● After a component is replaced, an inverter with activated Safety Integrated
will report what type of component has been replaced using a unique code.
10 Improved direct-component control in PM230
● Optimized efficiency for pump and fan applications
11 Rounding down of BACnet and macros
480
✓
✓
✓
-
-
-
✓
✓
✓
-
-
Converter with the CU240B-2 and CU240E-2 Control Units
Operating Instructions, 01/2017, FW V4.7 SP6, A5E34259001B AD
SINAMICS
G120 G120D
✓ ✓ ✓ ✓ ✓ ✓
✓ ✓ ✓ ✓ ✓ ✓
✓ ✓ ✓ ✓ ✓ ✓
- - - - - ✓
- - - - - ✓
- - - - ✓ -
✓ ✓ - ✓ ✓ ✓
✓ ✓ - ✓ ✓ ✓
✓ - - ✓ ✓ ✓
- ✓ - - - -
- ✓ - - - -
✓
✓
✓
-
-
-
✓
✓
✓
-
-