Backing Up And Transferring Settings Using A Memory Card; Memory Cards - Siemens SINAMICS G120 Operating Instructions Manual

Saving the settings and series commissioning

7.1 Backing up and transferring settings using a memory card

7.1 Backing up and transferring settings using a memory card
7.1.1

Memory cards

Recommended memory cards
Table 7-1
Scope of delivery
Memory card without firmware
Memory card with firmware V4.7
Memory card with firmware V4.7 SP3
Memory card with firmware V4.7 SP6
Using memory cards from other manufacturers
The inverter only supports memory cards up to 2 GB. SDHC cards (SD High Capacity) and
SDXC cards (SD Extended Capacity) are not permitted.
If you use other SD or MMC memory cards, then you must format the memory card as follows:
● MMC: Format FAT 16
– Insert the card into your PC's card reader.
– Command to format the card:
● SD: Format FAT 16 or FAT 32
– Insert the card into your PC's card reader.
– Command to format the card:
Functional restrictions with memory cards from other manufacturers
The following functions are either not possible – or only with some restrictions – when using
memory cards from other manufacturers:
● Licensing functions is only possible using the recommended memory cards.
● Know-how protection is only possible with one of the recommended memory cards.
● Under certain circumstances, memory cards from other manufacturers do not support
writing or reading data from/to the inverter.
348
Memory cards to back up inverter settings
format x: /fs:fat (x: Drive code of the memory card on your PC)
format x: /fs:fat or format x: /fs:fat32 (x: Drive code of the memory card on your PC.)
Article number
6SL3054-4AG00-2AA0
6SL3054-7EH00-2BA0
6SL3054-7TB00-2BA0
6SL3054-7TD00-2BA0
Converter with the CU240B-2 and CU240E-2 Control Units
Operating Instructions, 01/2017, FW V4.7 SP6, A5E34259001B AD