Changing Settings Using Bop-2 - Siemens SINAMICS G120 Operating Instructions Manual
Low voltage converters
chassis devices with cu240b-2 and cu240e-2
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
A.2.1
Changing settings using BOP-2
Changing settings using BOP-2
You can modify the settings of your inverter by changing the values of the its parameters. The
inverter only permits changes to "write" parameters. Write parameters begin with a "P", e.g.
P45.
The value of a read-only parameter cannot be changed. Read-only parameters begin with an
"r", for example: r2.
Procedure
To change write parameters using the BOP-2, proceed as follows:
1. Select the menu to display and change
parameters.
Press the OK key.
2. Select the parameter filter using the
arrow keys.
Press the OK key.
– STANDARD: The inverter only
– EXPERT: The inverter displays all
3. Select the required number of a write parameter using the arrow keys.
4. Select the value of the write parameter using the arrow keys.
You have now changed a write parameter using the BOP-2.
The inverter saves all the changes made using the BOP-2 so that they are protected against
power failure.
Converter with the CU240B-2 and CU240E-2 Control Units
Operating Instructions, 01/2017, FW V4.7 SP6, A5E34259001B AD
displays the most important
parameters.
of the parameters.
Press the OK key.
Accept the value with the OK key.
A.2 Handling the BOP 2 operator panel
Appendix
485
Advertisement
Table of Contents
