Circuits Configuration - Alcatel-Lucent 9500 MXC User Manual

Circuits Configuration

3DB 23063 ADAA - Rev 004 July 2007
Item Description
4 From, To and Port tabs are used to set circuit connections for unallocated tribs,
or to disconnect tribs. The disconnect option supports bulk Link or Data
disconnection with the toggle up, or circuit-by-circuit disconnection with the
toggle down.
5 A port refers to the circuit timeslot to/from the backplane bus. In this example,
each timeslot is an E1. This field is used to view, check, and where required, to
edit port-to-port connections.
Figure 9-3illustrates on-screen functionality for new circuit connections, based
on the configuration illustrated in Figure 9-1 and Figure 9-2.
The Procedure for Configuring Circuits - Traffic on page 9-9 describes the
configuration process.
Establishing New Circuit Connections
Figure 9-3.
1
2
Item Description
1 Click on a module to set the From selection.
2 Click the To tab to view set the To selection. In this example the Link to
Belmont is From, and the DAC 16x is To.
9500 MXC User Manual
3
Vol. IV-9-5