Alcatel-Lucent 9500 MXC User Manual page 346

Chapter 2. Setting Up 9500 MXC CT
Installing a COM Port Communications Cable Connection: Windows XP
1
The COM port number will be the number selected in step 7.
Vol. IV-2-14
10. Leave the Username and Password blank and click Next.
11. Click on Add a shortcut to this connection to the desktop.
12. Click Finish.
To check setup and operation, refer to Starting 9500 MXC CT on page 2-19.
This procedure sets up a communications-cable connection between your CT PC
and 9500 MXC. There is no need to first install the 9500 MXC modem driver.
To configure the connection:
1. From the PC Control Panel, select
.
connection
The New Connection Wizard is displayed.
2. Click .
Next
3. Select
Set up an advanced connection and click Next.
4. Select
Connect directly to another computer and click Next.
5. Select Guest and click Next.
6. name, such as 9500 MXC, and click Next.
Enter a computer
7. Select a COM port, such as COM1, and click Next.
Ensure the COM port selected has not been configured to share dial-up drivers
for other devices. If an existing modem driver is configured on the COM port, this
communications cable procedure will not operate. Where a conflict exists,
remove the competing drivers.
8. Select Anyone's use and click Next.
9. Click add a shortcut to place a shortcut on your desktop, and click Finish to
complete.
10. The Connect 9500 MXC window is presented. Ignore the User name and
Password fields and click Properties.
11. Under General, the Select a device field displays the configured COM port
and parallel port options. Select Communications cable between two
computers (COM1)
12. In the Maximum speed (bps) field, use the drop-down menu to select 38400.
Under Hardware features check the default settings, which should only
indicate a tick in Enable hardware flow control.
Network Connections
1
and click Configure.
>
Create a new
Alcatel-Lucent